You can configure the sensor WS433 remotely via the Wireless coordinator it is connected with.
- Every sensor WS433 has a configuration table in the memory map of Wireless Co-ordinator it connected with;
- Once you changed the value of registers in that memory map, the Wireless co-ordinator will send this changed value to sensor WS433 upon the WS433 send data to Wireless Co-ordinator;
Therefore, after changing the value in the memory map, you need to wait for the next sending cycle of WS433 for it to send data to the Wireless co-ordinator so that it can get the new configuration.
For example, if the cycle sending of WS433-ATH is 2 minutes, you need to wait up to 2 minutes so that the new configuration is synchronized to the sensor successfully.
You can check the sensor status to see whether it was loaded new configuration or not, please read this article:
Refer to the Memory map File of WS433-CL you will know the register address of each parameter of sensor for configuration.
You can download the file here.